Chrome 1 3/4" LAF L.A.F Porkers Exhaust Drag Short Pipes Harley Softail 86-2017

Description

BRAND NEW
PART# ACMCHROMEPORKERS
Should fit all 1986 to 2017 Softail Models and
may
(no guarantee) fit others at your own risk.
This set features 1-3/4" tubing
Includes generic mounting bracket that attaches the two pipes together
Includes 02 plugs and 18mm to 12mm adapters ( value at no extra charge)
There is no warranty on exhaust pipes especially with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc, and is not
caused by defective manufacturing.
For the best performance, a free-flowing air cleaner and carb re-jet kit or adjustable fuel management system is recommended with this pipe
and any exhaust modification.
READ ALL TECH NOTES!
1984-2017 Harley Softail Models. Have not verified fitment on models with O2 sensors
1991-2017 Dyna FXD / FXDWG with
forward controls only but have no yet verified fitment
Custom Choppers with either left or right side drive.
1986-2019 Sportster models with
forward controls only. 2014 & up will work with 12mm sensors. 2007-2013 models will have to use power commander because we have not verified if 18mm O2 sensor will fit
Possibly Touring Models 1984-2016 but have not verified fit
Bobber / Chopper / Custom Bike Motorcycle
** Tech Note: These will not work with mid controls that are in the way of these pipes.
** Tech Note: In many cases the generic bracket that holds the pipe together may NOT work. You have to rig the bracket or make something. It's pretty simple as you only need to figure out a method to secure the two pipes to each other and not the frame.
** Tech Note: On Dyna and probably touring models you will not be able to access the oil cap without loosening or removing the pipes. They are so light and easy to remove, it really shouldn't be a big deal. Also on the newer Dynas, whens stock air cleaner pictured is being used, you may need to notch or clearance the stock air cleaner. We also have not verified if the O2 sensors will have clearance.
** Tech Note: Check inside O2 Bungs to make sure hole is large enough for O2 sensor. Sometimes they will need to be enlarged using a die grinder or dremell.
** Tech Note: Run chase through thread in O2 bung prior to installation of sensor or plug.